User manual
Table Of Contents
- 1. About This Manual
- 2. General Information
- 3. Installation
- 3.1 Performing the Installation
- Step 1. Unpacking the StorageLoader
- Step 2. Installing the StorageLoader in a Rack
- Installing the Rack Mounting Kit
- Installing the “Rail Left Assembly”
- Installing the “Rail Right Assembly”
- Mounting the StorageLoader to the Rack
- How to dismount the StorageLoader from the rack
- Step 3. Connecting Power Cable
- Step 4. Removing the Transport Lock
- Step 5. Running Power-On Selftest
- Step 6. Setting the SCSI Address
- Step 7. Connecting the SCSI Bus Cable
- Step 8. Connecting the Ethernet Connector
- Step 9. Restarting Your System
- Step 10. BCR: Labelling of cartridges
- Step 1. Unpacking the StorageLoader
- 3.1 Performing the Installation
- 4. Operation and Configuration
- 1.
- 5. Remote Management
- 6. Maintenance
- 7. Troubleshooting
- Appendix A – Specifications
- Appendix B – Spare parts/Accessories
- Appendix C – Field Replacement Units (FRUs)
Tandberg Data Operation and Configuration
Cartridge Magazines
There are two removable magazines (FRUs), each holding four tape cartridges, see
figure 2.4. The magazine includes design features to ensure that cartridges are
always inserted correctly and stay securely seated. All magazine handling is
described in detail in section 4.8, Magazine Handling.
The Cartridge Slots in the magazines are numbered as shown in figure 2.3
Figure 2.4 Cartridge magazines
Power Supply
The power supply regulates the electrical power supplied to the device. It is easily
removable (FRU) for quick field service; see Appendix C
2.2.2 Rear Panel
The figure below shows the rear panel of the StorageLoader.
Figure 2.5 Rear panel of the StorageLoader
Integrated Cooling Fans
The rear panel contains forced-air cooling fans, which draw air inward through the
front and expel it out in the back. The fans will start whenever the drive is operating
StorageLoader Installation and User Manual 9