Datasheet

72
PRODUCT MANUAL 1016988
CHAPTER 3—CONFIGURING THE LIBRARY
Viewing the MAC Address
1.
1.1.
1. To view the MAC address, press until the selection arrow ( ) points to
MAC Address.
2.
2.2.
2. Press Select.
3.
3.3.
3. Press OK.
4.
4.4.
4. Press Back (as needed) to return to the Home screen.
SETTING USB OPTIONS
You can use the library’s USB to share the user selectable configurations
between libraries. Also see “USB Port—Library Firmware Upgrade and
Diagnostics” on page 190 and “USB Port—Tape Drive Firmware Upgrade” on
page 194.
To share the configuration settings between libraries, you need to perform
these two steps:
 Save configuration to USB —The library writes data to the file shown
(CAL3CLON.BIN) that contains the user selectable configuration values
(SCSI IDs, I/E Port Enable, Cleaning Cartridge Information, SCSI element
addresses, emulation mode, language, password, saved Mode Select data,
drive configuration, and so forth).
Ethernet
DHCP
IP Address
Subnet Mask
Gateway
MAC Address
Select Back
Ethernet
MAC Address:
nn ln nn nn nn ln
OK