Datasheet

66
PRODUCT MANUAL 1016988
CHAPTER 3—CONFIGURING THE LIBRARY
Enabling Network Addressing and Setting the Ethernet Addresses
To enable or disable Network addressing:
1.
1.1.
1. At the Home screen, press Lib.
If necessary, enter the operator panel password (see page 78).
SNMP If you are using a network-based monitor/management
application other than the library’s Remote Management utility,
you may need to identify the library’s Simple Network
Management Protocol (SNMP) settings to the application. These
settings include:
 Read community string
 Write community string
 Broadcast community string
 Trap address
 Trap port
You can view and change these settings only through the
library’s Remote Management utility. See Chapter 4 for
instructions.
FTP Interface The library also includes an FTP interface that you can use to
transfer firmware files or create diagnostic listings. You can:
 Set up an FTP user name and password for this interface or
use the library’s defaults
 View and change the FTP settings only through the library’s
Remote Management utility
 For instructions, see Chapter 4.
For information about accessing the library’s FTP interface and
using an FTP utility to upgrade firmware or obtain diagnostic
listings, see page 188.
Table 3-7 Ethernet configuration options (continued)