Datasheet

APRIL 2007 STORAGELOADER 2U LTO
65
SETTING CONFIGURATION OPTIONS
5.
5.5.
5. Press or until the selection arrow ( ) points to Enable, and then press
Select.
6.
6.6.
6. Press OK.
7.
7.7.
7. Press Back (as needed) to return to the Home screen.
SETTING ETHERNET CONFIGURATION OPTIONS
Auto Cleaning
Enable
Disable
Select Back
Table 3-7 Ethernet configuration options
Remote
Management
Utility
The Remote Management utility allows you to connect to the
library’s Ethernet interface to remotely monitor operations,
upgrade firmware, and create diagnostic listings. See:
 Connecting the library to Ethernet—page 21
 Using the Remote Management utility—Chapter 4
Ethernet Configuring the library’s Ethernet interface typically involves
specifying the library’s IP address, subnet mask, and gateway
address.
 IP address—Used to route information from the library to the
server. You can choose between dynamic (server-assigned)
or static (user-assigned) addressing for the IP address.
 Subnet Mask—Used to route information to designated
devices within the network.
 Gateway address—Allows information to be routed outside
the subnet.
 MAC address—Displays the Media Access Control address for
the library.
Network
Addresses
This allows you to select the method used to set the Internet
Protocol (IP) address for the library, as follows:
 Static—The library uses a fixed IP Address, which is assigned
in the IP Address option.
 DHCP—The library uses an IP address assigned by the
network DHCP (Dynamic Host Configuration Protocol)
server. This is the default setting for the library (DHCP
enabled).
+–
–+