Datasheet

APRIL 2007 STORAGELOADER 2U LTO

SETTING CONFIGURATION OPTIONS

6.6.

6. Press OK.

7.7.

7. Press Back (as needed) to return to the Home screen.

The Home screen now indicates that the library is operating in Sequential

Mode by the following changes.

 Lib (Library) is replaced with Seq (Sequential).

 D-1 (Drive-1) and D-2 (Drive-2) are replaced with A-1 and A-2

(indicating autoload function).

SETTING UP AUTOMATIC TAPE DRIVE CLEANING

The Autoclean option enables the library to automatically perform tape drive

cleaning without operator intervention. When Autoclean is enabled, the

library monitors the cleaning requirements of the tape drive(s). When a tape

drive indicates it needs cleaning, the library loads the cleaning cartridge into

the tape drive. After the cleaning cycle is complete, the tape drive unloads and

ejects the cleaning cartridge, and the library resumes operation.

Note: You do not have to use the library’s Autoclean option to clean the tape

drive(s). You can choose from several other cleaning methods, including

using your backup application’s cleaning function and using commands

available through the operator panel. See page 130 for information about

these cleaning alternatives.

Setting up automatic tape drive cleaning involves two procedures:

 Activating the cleaning cartridge cell

 Enabling the Autoclean option

TANDBERG DATA

StorageLoader 2U LTO

Seq

A-2

A-1

Idle

No Tape

Move Lib Maint Drive

! !

! Important

If you plan to use automatic cleaning, the cleaning cartridge

should be stored in:

 Slot/Cell 2—if the I/E Port is enabled

 Slot/Cell 1—if the I/E Port is disabled

If your backup application has a cleaning option, be sure to turn

that option OFF.