Datasheet

54
PRODUCT MANUAL 1016988
CHAPTER 3—CONFIGURING THE LIBRARY
2.
2.2.
2. Press until the selection arrow ( ) points to Drive Configuration.
3.
3.3.
3. Press Select.
Note: The library lists “no drive” only if there is no room for more tape
drives. For example, in the above screen, the library has one full
height tape drive installed. The “2” tape drive number is for two half
height tape drives.
4.
4.4.
4. Press Modify. Press or until the selection arrow ( ) points to the
desired configuration. Press Select.
Notes: This menu option requires input for all of the tape drives installed in
the library. If you press “Back” before configuring all the tape drives,
the configuration selection will not change.
5.
5.5.
5. Press OK. Repeat the process for each tape drive installed.
6.
6.6.
6. Press Back (as needed) to return to the Home screen.
Drive
Drive ID
Interface
Drive Configuration
Library SCSI Bridge
Select Back
Drive Configuration
1: IBM LTO FullHigh
2: no drive
Modify OK
Select Drive 1
HP LTO HalfHigh
IBM LTO FullHigh
Select Back