Datasheet

APRIL 2007 STORAGELOADER 2U LTO
53
SETTING CONFIGURATION OPTIONS
4.
4.4.
4. Press Modify. Press or to select the desired tape drive. Press Select.
The following screen appears.
5.
5.5.
5. Press OK to accept the change or back to cancel the change.
6.
6.6.
6. Press Back (as needed) to return to the Home screen.
TAPE DRIVE CONFIGURATION
If you replace a tape drive, or add a second half-height tape drive to your
library, you must set the tape drive configuration to match the tape drives that
are installed in the library.
To set tape drive configuration:
1.
1.1.
1. At the Home screen, press Drive.
If necessary, enter the operator panel password (see page 78).
Library SCSI Bridge
Drive ID
01 02
Address: 0051 (element address)
Drive 1: (empty)
Select Back
Pending Action:
Library SCSI Bridge
Reset Will Occur!
Continue?
OK Back
+–
–+