Datasheet

52
PRODUCT MANUAL 1016988
CHAPTER 3—CONFIGURING THE LIBRARY
TAPE DRIVE SCSI INTERFACE (LIBRARY BRIDGE)
If you have two tape drives installed in the library, you can assign one of them
to act as the primary SCSI interface (bridge) for the library. If you have only
one tape drive installed, it automatically acts as the SCSI bridge.
Note: The library communicates with the host through the SCSI interface of the
tape drive(s) via the ADI serial interface. The SCSI interface as seen by the
host is the SCSI interface of the tape drive.
See the tape drive Product Manual for tape drive information.
See Automation/Drive Interface - Command (ADC) for ADI information.
To assign the tape drive SCSI bridge:
1.
1.1.
1. At the Home screen, press Drive.
If necessary, enter the operator panel password (see page 78).
2.
2.2.
2. Press until the selection arrow ( ) points to Library SCSI Bridge.
3.
3.3.
3. Press Select.
Drive
Drive ID
Interface
Drive Configuration
Library SCSI Bridge
Select Back
Library SCSI Bridge
Drive: nn
Modify OK