Datasheet

28
PRODUCT MANUAL 1016988
CHAPTER 2—INSTALLING THE LIBRARY
3.
3.3.
3. Ensure that both magazines are fully seated. Once they are fully seated, the
library updates its inventory. While updating inventory, the library
displays the inventory status (XX%).
4.
4.4.
4. Set the SCSI IDs. If necessary, set the SCSI IDs for the tape drive(s)—You
can use the default IDs or change them if they conflict with other devices
on the SCSI bus. See page 50 for instructions.
5.
5.5.
5. Final step. Power on the host computer system.
VERIFYING THE HARDWARE INSTALLATION
After the library powers on, the LCD displays the Home screen. The first line
of the Home screen displays the product name and the following lines show
status for the library and tape drive or tape drives.
Note: This screen shows a library configured with two tape drives. If your library
has one tape drive installed, the additional line (D-2) does not show a
status.
If the library powered on as described, continue with configuration in
Chapter 3. If not, refer to the following information.
TANDBERG DATA
StorageLoader 2U LTO
Lib
XX%
D-1
:
:
:
Update Inventory
(Current action)
No Tape
Move Lib Maint Drive
!
! !
! Important
Do not power on the host computer system immediately after
powering on the library. After you power on the library, there is a
short delay before the tape drive (or tape drives) are on-line.
TANDBERG DATA
StorageLoader 2U LTO
Lib
D-2
D-1
:
:
:
Idle
No Tape
No Tape
Move Lib Maint Drive