Datasheet

APRIL 2007 STORAGELOADER 2U LTO
23
POWERING ON THE LIBRARY
2.
2.2.
2. Connect the female end of the power cord to the power connector on the
back of the library.
3.
3.3.
3. Plug the male end of the power cord into the power source.
4.
4.4.
4. Push the power switch on the back of the library to the “on” position (press
the I
II
I). The library performs its power-on sequence.
If you previously removed the shipping lock (using the Quick Start Guide), skip
the next section and continue with “Completing the Power-on Sequence” on
page 27.
REMOVING THE SHIPPING LOCK
The library automatically ejects both left magazines and displays the following
message when you power it on with the shipping lock installed.
1.
1.1.
1. Remove the left magazine. Press the left magazine eject button, if needed.
While supporting it, gently slide the magazine straight out of the library.
!
! !
! Important
Two power cords are shipped with the library: One for use in the
US and Canada, and one for use in Europe. See page 210 for
power cord requirements for other locations.
TANDBERG DATA
StorageLoader 2U LTO
Lib : Hardware Error
Picker ship-lock
1) Remove Picker Lock
2) Reset Library
Move Lib Maint Drive
Caution
Use care not to twist the magazine or move it side to side as you insert or
remove it from the library. Not inserting it straight into / pulling it straight out of
the opening can damage components inside the library.