Datasheet

APRIL 2007 STORAGELOADER 2U LTO
245
LIBRARY ERROR MESSAGES
I/E Port Disabled The requested action cannot
be done because the I/E port
is disabled.
 Determine that the I/E port should be disabled
and try a new command.
-or-
 Enable the I/E port and retry the command. See
“Enabling and Disabling the I/E Port” on
page 47.
I/E Port Unlocked Import/Export element is
unlocked.
Close I/E Port and retry the operation.
See “Loading Cartridges into the I/E Port” on
page 118.
Invalid Cartridge An attempt was made to
load an incompatible
cartridge or a spent cleaning
cartridge into a tape drive
and the cartridge was
ejected.
 Remove the cartridge from the library and
replace it with one that is compatible with the
tape drive. See “Tape drive cartridge read/write
compatibility” on page 117.
 If you were attempting to import a cleaning
cartridge, insert a cartridge with cleaning cycles
remaining on it.
Invalid Data The library detected that the
data read from the USB file
is not the desired data.
1. Ensure that the correct data is in the file,
re-write the file to the USB device, and retry
the operation.
2. Retry with another USB device.
If the error persists, contact Technical Support
(see page iii) or your service provider.
Invalid NVRAM An operation couldn’t be
completed because the
stored parameters are not
valid.
1. Reset the library and retry the operation.
2. Use “Restore Defaults” from the Library
Settings menu to refresh the library settings.
3. If the error persists, contact Technical Support
(see page iii) or your service provider.
Invalid Password The password you entered
does not match the saved
password that is protecting
this system.
Enter the valid password.
See “Setting up an operator panel password” on
page 76.
Magazine Unlocked Magazine is unlocked. Close the magazine and retry the operation.
See “Loading Cartridges into a Magazine” on
page 122.
No Cleaning Tape The library cannot clean the
tape drive since there is no
cleaning cartridge in the
fixed cleaning cell.
Import an LTO cleaning cartridge and then move
it to the fixed cleaning cell.
Use only LTO cleaning cartridges with LTO tape
drives.
See “Inserting and Moving Cartridges” on
page 118.
Table E-1 Library error messages (continued)
Error Message Description Corrective Action