Datasheet

APRIL 2007 STORAGELOADER 2U LTO
239
E
ERROR MESSAGES
This appendix defines error messages that may appear on the library’s front
panel and provides corrective actions.
LIBRARY LCD ERROR MESSAGES
This section describes the general error messages that can appear on the
library’s operator panel and provides corrective actions.
Ta b l e E - 1 lists library error messages in alphabetical order.
If the corrective action in the table:
 Instructs you to reset the library or tape drive, go to “Resetting the Library”
on page 136 for instructions.
 Does not correct the error, contact Technical Support at
www.tandbergdata.com or your service provider.
Caution
Most library components can be replaced only by Tandberg Data
Corporation-approved service providers. If you cannot find an obvious cause for
the problem, contact your service provider. Do not attempt to replace any
components other than the tape drive(s) or the magazine(s). If you do, you will
void your warranty.
!
! !
! Important
Some corrective actions advise you to reset or power the library off and back on.
To avoid disrupting communication between the host computer and other devices
on the bus, make sure that there is no activity on the bus before you reset or
power off the library.
If you need to power the library off, first unload the cartridge from the tape
drive(s), if possible. If you power the library off and back on while a cartridge is in
a tape drive, the tape drive may have to perform a lengthy format recovery
process.