Datasheet

190
PRODUCT MANUAL 1016988
CHAPTER 7—MAINTENANCE
5.
5.5.
5. If necessary, rename the firmware file(s) you downloaded from
www.tandbergdata.com as follows:
 Library firmware: Change “filename.bin” to “libflash.bin”
 Ethernet module firmware: Change “filename.hex” to “enet.hex”
Use the FTP command for your utility to transfer the new firmware to
the library. For example, issue a “put libflash.bin” command.
The system initiates the firmware upgrade and displays its progress on the
library’s LCD. When the upgrade has completed successfully, the library
automatically resets.
CREATING A DIAGNOSTIC LISTING VIA FTP
To create a diagnostic listing via FTP:
1.
1.1.
1. Connect to the library’s FTP interface by following the instructions on
page 188.
2.
2.2.
2. Make sure that the FTP file transfer type is set to binary.
3.
3.3.
3. Use the FTP command for your utility to get the diagnostic listing.
For example, issue the “get libdump.bin” command.
4.
4.4.
4. If necessary, specify a destination location (path and filename) for the
diagnostic listing.
LIBTOOL—LIBRARY FIRMWARE UPGRADE
You can also use LibTool to upgrade firmware over the SCSI interface.
 LibTool is available as a free download at www.tandbergdata.com.
 Refer to the readme file provided with the program for installation
instructions.
 Refer to the program’s online help for instructions on performing
upgrades and diagnostics.
 You can download new firmware at www.tandbergdata.com.
USB PORT—LIBRARY FIRMWARE UPGRADE AND DIAGNOSTICS
You can use the USB port to upgrade library firmware and create diagnostic
listings. See “Connecting the Library to the USB Port” on page 21.
Caution
Do not attempt to perform library operations or power down the library until after
it automatically resets.