Datasheet

APRIL 2007 STORAGELOADER 2U LTO
189
FTP—LIBRARY FIRMWARE UPGRADE AND DIAGNOSTICS
 A host computer or network connection that uses a pin-through-hole RJ-45
shielded Ethernet connector
To access the library’s FTP interface:
1.
1.1.
1. Connect the Ethernet cable as described on page 21, and set Ethernet
configuration options as described on page 65. Make a note of the library’s
IP address.
Note: If you set DHCP on, you can view the current server-assigned IP
address for the library through the Library’s Settings menu (see
page 150).
2.
2.2.
2. From your host computer, activate the FTP utility you are going to use.
Connect to the library using the library’s current IP address.
3.
3.3.
3. Log into the library’s FTP interface using the library’s FTP default user
name and password:
User name: anonymous
Password: Exabyte
Note: The user name and password are case-sensitive. If desired, you can
change the user name and password from their defaults through the
library’s Remote Management utility (see Chapter 4).
UPGRADING LIBRARY FIRMWARE VIA FTP
To upgrade the library’s firmware via FTP:
1.
1.1.
1. Obtain new firmware for the library. You can download new firmware from
www.tandbergdata.com. The firmware file for the library uses the
extension .bin. The firmware file for the Ethernet module uses the
extension .hex.
2.
2.2.
2. Connect to the library’s FTP interface by following the instructions in the
previous section.
3.
3.3.
3. Make sure that the FTP file transfer type is set to binary (ftp>bin).
4.
4.4.
4. Use the ”ls” command to list the files on the library.
 Library’s firmware file name: “libflash.bin”
 Ethernet module’s firmware file name: “enet.hex”
Note: If desired, you can make a copy of the current firmware file(s) by
using a “get FTP” command.
!
! !
! Important
Make sure that you select and download the correct firmware
files. Firmware for other Tandberg Data Corporation products is
also on this web site and is not compatible with the
StorageLoader 2U LTO.