Datasheet

186
PRODUCT MANUAL 1016988
CHAPTER 7—MAINTENANCE
6.
6.6.
6. Press OK to perform the test.
Press STOP at any time to cancel the test.
7.
7.7.
7. Press Back (as needed) to return to the Home screen.
RUNNING A SYSTEM DEMO
The library has a built-in demo program for testing or demonstrating library
operation. When performing its demo program, the library loops through the
following functions:
 Moves the robot to a cell
 If the cell contains a cartridge, the library moves the cartridge to the tape
drive.
 If the cell does not contain a cartridge, the library moves the robot to a
cell that contains a cartridge.
 If the Load option (described in this chapter) is enabled, the library:
 Inserts the cartridge into a tape drive
 Waits for the tape drive to load the tape
 Instructs the tape drive to unload and eject the cartridge
 Returns the cartridge to its cell
 Repeats the above functions until any front panel button is pushed
To run a system demo on the library:
1.
1.1.
1. At the Home screen, press Maint.
If necessary, enter the operator panel password (see page 78).
Test: 0001 <Command> 05
Lib: Position <Command>
Positioning <Command State>
D-2: No Tape
D-1: No Tape
STOP