Datasheet

172
PRODUCT MANUAL 1016988
CHAPTER 7—MAINTENANCE
Single Half height tape drive: Install the tape drive in the lower opening,
and use the middle power connector (
P).
Serial—Route the serial cable (
S) over the tape drive carrier and under the
power cable; connect as shown in Figure 7-2 (HH serial cable routing).
Power—Route the power cable under the tape drive carrier as shown here;
connect as shown in Figure 7-4 (HH power cable routing).
d.
d.d.
d. Slide the tape drive the remaining distance into the library. Use care not
to damage the cables during this step.
4.
4.4.
4. Completing the installation—
a.
a.a.
a. Attach the SCSI cover plate and the tape drive cover plate that came with
your replacement kit. See “Reference Illustrations” on page 165.
Figure 7-11 Lower half height tape drive cable routing
Serial connector (S)
Power cable (P)
Second half
height power
connector (do not
use with only one
HH tape drive
installed)
(use middle connector)
Route both cables
over tape drive
carrier
(route under power cable)
Tape drive Quantity
Install in this
opening...
Serial
connector
Internal
label
Half height
Second tape drive Top Top Drive 2
Single tape drive Bottom Bottom Drive 1
Full height Single tape drive Bottom Bottom Drive 1
!
! !
! Important
The library requires both the SCSI cover plates and the tape
drive cover plates for ESD protection. Do not leave any
openings uncovered.
Do not connect the SCSI cables until after you reconfigure the
library.