Datasheet

164
PRODUCT MANUAL 1016988
CHAPTER 7—MAINTENANCE
✔ Obtain these items—a #2 Phillips screwdriver and a small flat-blade
screwdriver.
✔ Ensure that the environment is free of conditions that could cause
electrostatic discharge (ESD)—If possible, use an antistatic mat and a
grounded static protection wristband during installation. If a mat and
wristband are not available, touch a known grounded surface, such as a
computer’s metal chassis.
GENERAL INFORMATION
The StorageLoader 2U LTO will accommodate Ultrium 3 (LTO-3) tape drives
in a full height (FH) configuration or Ultrium 2 (LTO-2) tape drives in half
height (HH) or full height (FH) configurations. The library does not
accommodate LTO-1 tape drives.
Note: Most of the illustrations show SCSI configurations. Use the same steps to
install Fibre Channel tape drives.
Warning
Before performing any installation or maintenance procedures, be sure that
the library’s power switch is off and that the power cord is disconnected
from the library and the outlet.
Warnung
Vor der Ausführung von Installations- oder Wartungsarbeiten ist darauf zu
achten, daß der Library-Netzschalter auf “Aus” gestellt ist und daß das
Anschlußkabel vom Library und der Steckdose entfernt ist.
Advertencia
Antes de realizar cualquier procedimiento de instalación o de
mantenimiento, comprobar que el interruptor de alimentación de la
biblioteca está apagado y que el cable de alimentación no está enchufado
ni a la biblioteca ni a la toma de corriente.
!
! !
! Important
The tape drives must be specially configured (at the factory) for
use in a StorageLoader 2U LTO library. Purchase tape drive kits
only from Tandberg Data Corporation or Tandberg Data
Corporation-approved suppliers.
To view this information... go to...
Adding a second half height tape drive page 167
Replacing a tape drive with the same configuration
(half height -to- half height or full height -to- full height)
page 169
Replacing a half height tape drive with a full height tape drive page 173
Reconfiguring the library
(this step must be completed for the library to operate)
page 176
Resuming operation page 177
Confirming the installation page 178