Datasheet

136
PRODUCT MANUAL 1016988
CHAPTER 5—OPERATING THE LIBRARY
 The tape drive automatically performs the cleaning in less than a minute
and ejects the cartridge when finished.
 During the cleaning, the front panel displays an Clean Drive Active
message.
 After a successful cleaning, the library displays this confirmation
message: Cleaning Good. Once the message appears, press OK to
continue.
 If the cleaning was not successful, a message explaining the failure
appears on the screen. You may be prompted to insert a new cleaning
cartridge. See Appendix E, Error Messages.
 If necessary, use the Export command to remove the cleaning cartridge
from the library, as described on page 124. Before closing the I/E port
door, insert the data cartridge you removed previously (if applicable).
Then, firmly push the door closed.
7.
7.7.
7. Press Back (as needed) to return to the Home screen.
RESETTING THE LIBRARY
If the library or tape drive has encountered an error and is not operating as
expected after you have tried the recommended corrective actions, you may
need to perform a reset.
 Front panel reset—Instructions begin on page 137.
 Back panel reset—You can reset both the library and the tape drive(s) by
powering the library off and back on (press the
0 to power the library off,
and then press the
I to power the library back on).
Note: You may also be able to perform resets from your application software.
Refer to your software documentation for instructions.