Datasheet

APRIL 2007 STORAGELOADER 2U LTO
95
SETTING CONFIGURATION OPTIONS
Notes: The library communicates with the host through the SCSI interface of
the tape drive(s) via the ADI serial interface. The SCSI interface as
seen by the host is the SCSI interface of the tape drive. The library is
shown as LUN 1 of the tape drive’s SCSI ID.
For additional information, see:
The tape drive’s Product Manual for tape drive information.
Automation/Drive Interface - Command (ADC) for ADI information.
SCSI Bridge If you have two tape drives installed in the library, you can
assign one of them to act as the primary SCSI interface (bridge) for the library.
If you have only one tape drive installed, it automatically acts as the SCSI
bridge.
 SCSI configuration—to change the SCSI bridge assignment, click the
radio button to the right of the tape drive and click Update.
 Fibre Channel configuration—to change the SCSI bridge assignment,
click the radio button to the right of the tape drive and click Update.
 See “Advanced” on page 113 for instructions on how to reset the library.
 See “Tape Drive SCSI Interface (Library Bridge)” on page 52 to set the SCSI
bridge from the front panel.
!
! !
! Important
Once you click the Update button and receive the
confirmation message, you must reset the library.