Datasheet

90
PRODUCT MANUAL 1016988
CHAPTER 4—USING THE REMOTE MANAGEMENT UTILITY
See “Loading Cartridges into a Magazine” on page 122 for instructions on
how to lock and unlock the magazines.
Left Magazine This indicates if the left magazine (if present) is locked or
unlocked. You can operate the library with one or two magazines (the second
magazine is optional). You can also limit the number of slots visible to the SCSI
interface for compatibility with backup software.
See “Setting the Data Cartridge Slot Count” on page 45
Library Temperature This indicates if there is a problem with the library’s
temperature.
See “Over Temperature” on page 247 for the corrective action for an over
temperature condition.
Auto Clean This indicates if Auto Clean is turned on or off.
See “Setting Up Automatic Tape Drive Cleaning” on page 61 to determine if
you want this function enabled or disabled.
Clean This indicates if a “fixed” cleaning slot has been set. Use this function
in conjunction with the Auto Clean option.
See “Setting Up Automatic Tape Drive Cleaning” on page 61 for instructions
on how to set s fixed cleaning slot.
Cleans Remaining. This indicates the number of cleanings remaining on the
cleaning cartridge. See “Check the Cleaning Cartridge Status” on page 131 for
additional information.
Notes: The cleaning count information is stored in the cartridge, so it must be
used once to “start” the count. Until it is used the first time, the utility
displays an “unknown” status.
The utility only displays the count if it is known.
If there is no barcode label on the cleaning cartridge, a power cycle
causes the cleaning count information to be lost. If there is a barcode
label on the cleaning cartridge, the library stores the information and
recognizes it after a power cycle.
Tape drive status information
The Tape Drive Status section includes the following information.