Instructions

tams elektronik
!
English PZS-2
11. Check list for troubleshooting
 Parts are getting too hot and/or start to smoke.
Disconnect the system from the mains immediately!
Possible cause: one or more components are soldered incorrectly.
I n case you have mounted the module from a kit, perform a
visual check ( section 6.) and if necessary, remedy the faults.
Otherwise send in the module for repair.
 The train stops, restarts, stops again, and so forth.
Possible cause: The overload protection consistently switches on and
off the current circuit, due to overload or a short circuit.  Check if
there is a short circuit on the rails or if the locomotive´s current
consumption exceeds 1.000 mA.
 The train does not run. / Functional test: The lamp does not light.
Possible cause: The driving transformer has not been connected or
has been connected the wrong way around (connections "earth" and
"+" exchanged.)  Check the connections.
 The settings of the trimmer do not take any effect on phase length
of a stop.
Possible cause: The settings of the trimmer have not been saved or
have been saved for another stop.  Program the phase length
anew for the stop concerned. See information on the programming
steps 1 and 3.
 The train does not stop at a station or a stop.
Possible cause: The cuts are placed badly or the sections are
connected the wrong way.  Check the placing of the cuts and the
connections of the sections.
Page 36