Instructions

tams elektronik
!
English PZS-2
Connecting stop diodes
In order to prevent trains running beyond the
end of the rails in the terminus stations 1 and
2, you can install extra stop diodes.
Connect them to the right rail – seen in the
train´s direction of travel. Cut the rail that way
that all current collectors driving the motor
have passed the cut-off before the train
reaches the end of the rails.
9. Operation
Caution:
The maximum current of a train in the shuttle-train section should not
exceed 1 000 mA (including all loads as e.g. carriage lightings). When
exceeding the maximum current, the integrated fuse switches off the
circuit. In the worst case components on the circuit can be damaged.
Run
Immediately after switching on the power supply for the module, the
shuttle-train traffic starts with a train starting from the terminus station
1 in direction of travel "way there".
Between the halts the shuttle-train traffic always runs in four phases:
acceleration, normal speed, braking and halt. As soon as a braking
phase has been triggered (i.e. the locomotive has run into the
respective section) the phases braking, halt and acceleration are time
controlled. During the phase "normal speed" the train is supplied with
the voltage set at the driving transformer. The phase "normal speed" is
interupted by releasing a new braking phase.
Page 30