Instructions

tams elektronik
English Power-Block
Required materials
To assemble the kit you will need
 a soldering iron with temperature control and a thin tip and a deposit
stand or a controlled soldering station
 a scraper, rag or sponge
 a heat-resistant pad
 a small pair of side cutters and wire strippers
 tweezers and flat-nose pliers if necessary
 electronic solder (preferably 0.5 to 0.8 mm diameter)
You need stranded wires to connect the module. The required cross-
sections depend on the load. Please observe the specifications of the
manufacturers of the circuits and components that you connect to the
Power Block.
Page 4