User manual

!
English Motor modification set
3. Safe and correct soldering
Caution:
Incorrect soldering can cause dangers through fires and heat. Avoid
these dangers by reading and following the directions given in the
chapter Safety instructions.
 Use a small soldering iron with max. 30 Watt or a regulated
soldering iron.
 Only use electronic tin solder with flux.
 When soldering electronic circuits never use soldering-water or
soldering grease. They contain acids that can corrode components
and copper tracks.
 Solder quickly: holding the iron on the joints longer than necessary
can destroy components and can damage copper tracks or soldering
eyes.
 Apply the soldering tip to the soldering spot in such a way that the
part and the soldering eye are heated at the same time.
Simultaneously add solder (not too much). As soon as the solder
becomes liquid take it away. Hold the soldering tip at the spot for a
few seconds so that the solder flows into the joint, then remove the
soldering iron.
 Do not move the component for about 5 seconds after soldering.
 To make a good soldering joint you must use a clean and unoxidised
soldering tip. Clean the soldering tip with a damp piece of cloth, a
damp sponge or a piece of silicon cloth.
 After soldering, check the PCB tracks for solder bridges and short
circuits created by accident. This would cause faulty operation or, in
the worst case, damage. You can remove excess solder by putting a
clean soldering tip on the spot. The solder will become liquid again
and flow from the soldering spot to the soldering tip.
Page 18
tams elektronik