User manual

tams elektronik
!
FI-1 English
7. Check list for troubleshooting
 Parts are getting too hot and/or start to smoke.
Disconnect the system from the mains immediately!
Possible cause: The supply voltage is too high. à Reduce the supply
voltage according to the specifications in the chapter "Technical
specifications".
Possible cause: The module is defective. à Return the module for
repair.
 The LED does not light.
Possible cause: None of the decoder outputs are active. à Check if
at least one of the function outputs of the decoder is switched on.
Possible cause: The connection to the power supply is interrupted.
à Check the connections.
Hotline: If problems with your module occur, our hotline is pleased to
help you (mail address on the last page).
Repairs: You can send in a defective module for repair (address on the
last page). In case of guarantee the repair is free of charge for you.
With damages not covered by guarantee, the maximum fee for the
repair is the difference between the price for the ready-built module
and the kit according to our valid price list. We reserve the right to
reject the repairing of a module when the repair is impossible for
technical or economic reasons.
Please do not send in modules for repair charged to us. In case of
warranty we will reimburse the forwarding expenses up to the flat rate
we charge according to our valid price list for the delivery of the
product. With repairs not covered by guarantee you have to bear the
expenses for sending back and forth.
Page 23