Manual

tams elektronik
!
Adapter for PluX22- and 21MTC-Interface tams elektronik
3.3. Soldering on the cables
Solder the connecting cables on the top side of the adapter PCB. Observe the different
assignments for PluX and MTC interfaces and the different mounting versions.
It is recommended to use cables of different colours according to NEM 658 or NEM 660 in
order to avoid mistakes when connecting the adapter PCB.
Perform a visual check!
After having soldered the cables you should perform a visual check and remedy defects.
 Check if soldering joints closely adjoining are connected to each other by accident. Risk of
short circuit!
 Check if you have assigned the connecting cables on the adapter PCB properly to the
connections of the decoder.
Caution:
Confusing the connections can cause damages at the deocder and/or at the vehicle. For that
reason you should be very attentive when assigning the connections.
3.4. Assignment for PluX adapters (NEM 658/RCN-122)
PluX adapter
Mounting version 1
Inserting direction of the decoder:
from above
Mounting version 2
Inserting direction of the decoder:
from below
Figure: Top side of the adapter PCB
Assignment for use according to PluX (NEM 658 / RCN-122)
11 = Index-Pin
8 | Assembling the kit