User manual

tams elektronik
Adapter for PluX22-, 21MTC- and SUSI-Interface English
Pin Name Description MTC adapter Cable colour
8 F0f lighting backward direction white
9 LS/A loudspeaker connection A brown
10 LS/B loudspeaker connection B brown
11 Index not in use, coding
12 Vcc internal decoder voltage 1,8 – 5,7 volts
13 AUX3 output 3
14 AUX2 output 2 violet
15 AUX1 output 1 green
16 V+ decoder plus, pick-off after rectifier,
connection storage capacitor
blue
17 AUX5 output 5
18 Motor2 motor connection 2 minus / backwards grey
19 Motor1 motor connection 1 plus / forwards orange
20 GND decoder ground, pick-off after rectifier
21 rails left rails left in forward direction of motion black
22 rails
right
rails right in forward direction of
motion
red
7.3. Soldering a plug for the the SUSI interface
As needed you can solder an additional plug for the SUSI interface to
the PCB (not with mounting versions 2). Solder the plug with its four
pins to the four connecting pads in the middle of the PCB and the
solder points at the housing to the two connecting pads at the PCB´s
edge.
Hint: When using a decoder with SUSI interface, you should connect
the SUSI module to the decoder´s SUSI interface.
Page 15