User manual

tams elektronik
SAS modules English
Checking the package contents
Please make sure that your package contains:
 one kit, containing the components listed in the parts list and one
PCB or
 one ready-built module or
 one ready-built module in a housing (complete unit),
 three push-buttons (2 x red, 1 x black),
 one manual.
There is no servo included in the package.
Required materials
For assembling the kit you need:
 an electronic soldering iron (max. 30 Watt) or a regulated soldering
iron with a fine tip and a soldering iron stand,
 a tip-cleaning sponge,
 a heat-resistant mat,
 a small side cutter and wire stripper,
 as necessary a pair of tweezers and long nose pliers,
 electronic tin solder (0,5 mm. diameter).
In order to connect the module you need wire. Recommended
diameters: > 0,14 mm² for all connections.
If you want to control the SAS via a digital points decoder, you
additionally need one or two relays (depending on the SAS version)
 section 4.
Page 4