User manual

tams elektronik
English SAS modules
Programming
After starting the programming mode you always have to pass through
all three programming steps. As long as the module is in programming
mode, the LED lights.
Push-
button
Effect
E1 or E2
programming step 1:
By pushing E1 or E2 you can alter end position A. As soon
as you have set the desired end position A, push SET.
SET  Saving the setting / finishing programming step 1.
E1 or E2
programming step 2:
By pushing E1 or E2 you can alter end position B. As soon
as you have set the desired end position B, push SET.
SET  Saving the setting / finishing programming step 2.
E1 or E2
programming step 3:
By pushing E1 or E2 you can alter the velocity. As soon as
you have set the desired velocity, push SET.
SET
 Saving the setting / finishing programming step 3. The
programming mode will be finished automatically, the LED
goes off.
Page 33