User manual

tams elektronik
!
SAS modules English
8. Programming the servo control
You can set the velocity and the two end positions of the servo
according individually to the needs by means of the three programming
push-buttons (connection according to connections diagram 1).
Attention: Do not set the SAS-3 while the HST PCB is
connected. Risk of short circuit! Disconnect the HST PCB if necessary
or switch of the track voltage.
Starting the programming mode
SAS-1
SAS-4
SAS-5
Operate push-button SET.
 The LED lights.
 The servo automatically drives to end position A.
SAS-2
SAS-3
Operate push-button SET, keep it in that position and at
the same time switch on the power supply.
 The LED lights.
 The servo automatically drives to end position A.
Page 32