User manual

tams elektronik
English SAS modules
You can keep the three push-buttons connected. It is recommended to
disconnect the push-button SET after final programming, in order to
avoid unintended re-programming.
Assignment of the SAS-PCB (except SAS-3)
 Return conductor for all push-buttons
E1
Programming push-button 1 / Push-button 1
SAS-1 push-button 1 direction 1
SAS-2 push-button  both directions
SAS-4 push-button 1 20-times repetition
SAS-5
push-button 1  without encompassing of the signal
box´s worker
SET Programming push-button "SET"
E2
Programming push-button 2 / Push-button 2
SAS-1 push-button 2 direction 2
SAS-2 ---
SAS-4 push-button 2  infinite repetition
SAS-5
push-button 2  without encompassing of the signal
box´s worker
+ | -
Transfomer. Check the polarity with the connection to d.c.
Voltage. When connecting the module to a.c. voltage the
polarity is of no importance.
Servo, impulse (signal)
+ Servo, voltage supply (+)
- Servo, voltage supply (-)
Page 27