User manual

tams elektronik

SAS modules English

7.2. Connecting the SAS

Connection diagram

First connect the three programming push-buttons, the servo and the

voltage supply to all versions of the SAS.

 programming push-button "SET": black push-button

 programming push-button 1 and 2 (connections E1 and E2): red

black push-buttons

Then check the servo and set the angle of rotation. Connect (with SAS-

3) the HST-PCB or a points decoder if necessary after having

performed a test and set the servo.

Attention:

When a component gets too hot, disconnect the module from the

voltage supply immediately. Risk of short circuit! Check the assembly.

Connect the functional model only after having performed a test and

set the servo. That is the only way to reliably avoid damages on the

model.

Do not set the SAS-3 while the HST PCB is connected. Risk of short

circuit! Disconnect the HST PCB if necessary or switch off the track

voltage.

Page 26