Instructions

tams elektronik
LC-Modules Next Generation English
Variant
Procedure
1 All the lights are switched on one after the other until the
lights at all 14 utputs are lit. Then the lights are switched
off again in reverse order.
2 The lights at outputs 1, 2, 3, 6 and 7 are switched on one
after the other. The two groups of 2 or 3 switched-on lights
continue to move, occasionally changing direction. This
gives the impression that the groups are following each
other.
3 First one light, then a group of first 2, then 3, 4, 5 and 6
lights run across the 14 connections one after the other.
Between the lights of a group, one output remains switched
off at a time.
4 The 14 lights are constantly switched on and off in such a
way that a switched-on light alternates with a switched-off
light. This gives the impression that the lights are moving
back and forth. After several light changes, two groups
flash alternately.
5 One after the other, all the lights are switched on in turn
until all 14 lights are lit. This is followed by three runs in
which one after the other of the 14 lights is switched off.
Finally, all lights are switched off again in reverse order.
6 The 14 lights are switched on and off seemingly randomly,
i.e. without any recognisable pattern.
7 One after the other, all the lights start flashing in sequence.
After all 14 lights have flashed simultaneously, the lights
are switched off again.
Page 87