Instructions
Table Of Contents
- Part A: General information
- Part B: LC-NG versions
- 1. LC-NG-01 "City Lighting"
- 2. LC-NG-02 "Residential buildings"
- 3. LC-NG-03 "Office and commercial buildings"
- 4. LC-NG-04 "Street lamps"
- 5. LC-NG-05 "Road traffic"
- 6. LC-NG-06 "Emergency vehicles"
- 7. LC-NG-07 "(Road) construction site"
- 8. LC-NG-08 "Fire station"
- 9. LC-NG-09 "Railway station"
- 10. LC-NG-10 "Workshop"
- 11. LC-NG-11 "Flickering flames & candle lights"
- 12. LC-NG-12 "Event"
- 13. LC-NG-13 "Chaser lights"
- 14. LC-NG-14 "Funfair lighting"
tams elektronik
English LC-Modules Next Generation
Servo
If you want to connect a servo to the module, you need:
a servo
a current and voltage supply (e.g. servo board item no. 70-05900-
01)
or an LC-NG servo set, consisting of servo, servo board and a 470 Ω
resistor (item no. 53-04321-01)
Note: Not all modules have an output for connecting a servo.
Loudspeaker
If you want to connect a loudspeaker to the module, you need:
a loudspeaker with an impedance of at least 8 ohms. Note: It is
recommended to use a loudspeaker with an impedance of: 32 or 50
ohms.
one choke 1 mH (e.g. item no. 84-30200-10)
two resistors 220 Ω/0.25 W or one resistor 470 Ω/1 W (e.g. item
no. 84-11134-10)
one electrolytic capacitor 22 F/25 V (e.g. item no. 84-43123-10)
or an LC-NG loudspeaker set consisting of a loudspeaker LSF-
27M/SC, a sound capsule, a choke 1 mH, two resistors 220 Ω/0.25
W, an electrolytic capacitor 22 μF/25 V (item no. 53-04311-01)
Note: Not all modules have an output for connecting a loudspeaker.
* In earlier versions of the manual, an electrolytic capacitor 220 µ/25 V was specified by
mistake. When using an electrolytic capacitor with this value, the sound reproduction is very
quiet.
Page 8