Instructions
Table Of Contents
- Part A: General information
- Part B: LC-NG versions
- 1. LC-NG-01 "City Lighting"
- 2. LC-NG-02 "Residential buildings"
- 3. LC-NG-03 "Office and commercial buildings"
- 4. LC-NG-04 "Street lamps"
- 5. LC-NG-05 "Road traffic"
- 6. LC-NG-06 "Emergency vehicles"
- 7. LC-NG-07 "(Road) construction site"
- 8. LC-NG-08 "Fire station"
- 9. LC-NG-09 "Railway station"
- 10. LC-NG-10 "Workshop"
- 11. LC-NG-11 "Flickering flames & candle lights"
- 12. LC-NG-12 "Event"
- 13. LC-NG-13 "Chaser lights"
- 14. LC-NG-14 "Funfair lighting"
tams elektronik
LC-Modules Next Generation English
Use of the switching input
Switching input Effect
Switch closed
(switched to earth)
Successive switching on of the lights in units
1 to 8
Switch open
Successive switching off of the lights in
units 1 to 8
Settings on the trim potentiometer
During operation, you can use the trim potentiometer to change the
maximum length of the pauses between successive switching on and
off of the lights in the 8 units. The length of the pauses is shorter in the
left-hand direction of rotation* and longer in the right-hand direction of
rotation.
Notes: The actual length of the pauses is randomly controlled, i.e. in
individual cases it can be significantly shorter than when set. When
switching off, the pause length is always shorter than when switching
on.
* Note: If the trim potentiometer is set to the left stop, the module goes into test mode when it
is switched on. You must therefore turn the potentiometer a little to the right after setting it to
the left stop in order to set the shortest possible pause length.
Page 61