Instructions
Table Of Contents
- Part A: General information
- Part B: LC-NG versions
- 1. LC-NG-01 "City Lighting"
- 2. LC-NG-02 "Residential buildings"
- 3. LC-NG-03 "Office and commercial buildings"
- 4. LC-NG-04 "Street lamps"
- 5. LC-NG-05 "Road traffic"
- 6. LC-NG-06 "Emergency vehicles"
- 7. LC-NG-07 "(Road) construction site"
- 8. LC-NG-08 "Fire station"
- 9. LC-NG-09 "Railway station"
- 10. LC-NG-10 "Workshop"
- 11. LC-NG-11 "Flickering flames & candle lights"
- 12. LC-NG-12 "Event"
- 13. LC-NG-13 "Chaser lights"
- 14. LC-NG-14 "Funfair lighting"
tams elektronik
English LC-Modules Next Generation
2. LC-NG-02 "Residential buildings"
2.1. Mode of operation
The outputs of the LC-NG-02 control the lights and televisions of two
houses (or flats) according to typical daily schedules. Subordinate circuits
can also be connected to the outputs, which are to be switched on and
off at the same time as the lights.
Two different programmes are available (house 1 & 2 or house 3 & 4).
The speed of the sequence can be adjusted at the trim potentiometer.
Synchronisation of several LC-NG-02 modules
As of software version 06/2021, it is possible to synchronise several LC-
NG-02 modules with each other. The synchronisation pulse is sent from
one module to all connected modules at programme time 0:45. This
ensures that the modules start their sequence at the same programme
time and that deviations in the set time factors do not play a role even
after several programme runs.
Use the switching input (from version 06/2021)
Switching input Effect
open No Synchronisation with other
modules LC-NG-02
closed
(connected to output 14 of the LC-NG-02
from which the synchronisation pulse is sent)
Synchronisation with other
modules LC-NG-02
Page 50