Instructions

tams elektronik
LC-Modules Next Generation English
 A connected servo does not work.
Possible cause: The servo is connected to the wrong output.
à Check the connection.
Possible cause: A connected switch is closed. à Check the position
of the switch.
Possible cause: The servo is connected to the servo board with the
wrong polarity. à Check the polarity of the servo.
Possible cause: The servo is defective. à Check the servo.
 A connected loudspeaker does not work.
Possible cause: The loudspeaker is connected to the wrong output.
à Check the connection.
Possible cause: The loudspeaker is connected to the switch input
instead of the return conductor. à Check the connection.
Possible cause: A connected switch is closed. à Check the position
of the switch.
Possible cause: The loudspeaker is defective. à Check the
loudspeaker
 The playback of the sound is very quiet.
Possible cause: No electrolytic capacitor 22 µF/>25 V was connected
for the filter, but an electrolytic capacitor with a larger capacity. à
Replace the electrolytic capacitor if necessary.
Hints: In the earlier versions of the instructions, an electrolytic
capacitor 220 µF/25 V was erroneously specified as part of the filter.
Until the end of June 2021, LC-NG speaker sets were delivered that
contained a 220 µF electrolytic capacitor instead of a 22 µF
electrolytic capacitor.
 Noise occurs during the playback of the sound.
Possible cause: The required filter at the loudspeaker connection or
parts of it are missing or incorrectly connected. à Check whether the
filter is connected according to section 7.5.
Page 41