Instructions
Table Of Contents
- Part A: General information
- Part B: LC-NG versions
- 1. LC-NG-01 "City Lighting"
- 2. LC-NG-02 "Residential buildings"
- 3. LC-NG-03 "Office and commercial buildings"
- 4. LC-NG-04 "Street lamps"
- 5. LC-NG-05 "Road traffic"
- 6. LC-NG-06 "Emergency vehicles"
- 7. LC-NG-07 "(Road) construction site"
- 8. LC-NG-08 "Fire station"
- 9. LC-NG-09 "Railway station"
- 10. LC-NG-10 "Workshop"
- 11. LC-NG-11 "Flickering flames & candle lights"
- 12. LC-NG-12 "Event"
- 13. LC-NG-13 "Chaser lights"
- 14. LC-NG-14 "Funfair lighting"
tams elektronik
!
English LC-Modules Next Generation
7.8. Connection test
With all versions of the LC-NG module, you have the option of testing
the functionality of the connected LEDs and lights.
Please note: Disconnect servos from the outputs before
carrying out a connection test. Otherwise there is a risk of damage to
the connected models.
To start the test, set the trim potentiometer to the left stop before
switching on the power supply. As soon as you have switched on the
power supply, all 14 outputs are switched on one after the other. You
can then see whether connected LEDs or light bulbs light up. The
programme sequence of the respective module has no influence on the
test mode.
After a single run, all lamps / LEDs are switched off again except for
those at output 12. To end the connection test, you must switch off the
power supply and turn the potentiometer a little to the right. Otherwise,
the LC-NG module will restart in test mode when you switch it on again.
Testing the potentiometer position
You can test the effect of the potentiometer position. To do this, start
the test mode (trim potentiometer to the left stop) and wait until all
outputs have been switched on and off again. Then turn the
potentiometer: At the minimum position, only the LED or light bulb at
output 1 is switched on. The further you turn, the more LEDs or light
bulbs are switched on. In the maximum position, the LEDs or light
bulbs at outputs 1 to 10 are switched on.
Page 34