Instructions
Table Of Contents
- Part A: General information
- Part B: LC-NG versions
- 1. LC-NG-01 "City Lighting"
- 2. LC-NG-02 "Residential buildings"
- 3. LC-NG-03 "Office and commercial buildings"
- 4. LC-NG-04 "Street lamps"
- 5. LC-NG-05 "Road traffic"
- 6. LC-NG-06 "Emergency vehicles"
- 7. LC-NG-07 "(Road) construction site"
- 8. LC-NG-08 "Fire station"
- 9. LC-NG-09 "Railway station"
- 10. LC-NG-10 "Workshop"
- 11. LC-NG-11 "Flickering flames & candle lights"
- 12. LC-NG-12 "Event"
- 13. LC-NG-13 "Chaser lights"
- 14. LC-NG-14 "Funfair lighting"
tams elektronik
English LC-Modules Next Generation
soldering, wipe off excess solder and dirt with a damp sponge, a
thick damp cloth or a silicone wiper.
After soldering, cut off the connecting wires directly above the
soldering point with a side cutter.
After assembly, always check each circuit again to ensure that all
components are correctly inserted and polarised. Also check that no
connections or tracks have been accidentally bridged with tin. This
can lead not only to malfunction, but also to the destruction of
expensive components. You can re-liquefy excess solder with the
clean hot soldering tip. The solder then flows from the board to the
soldering tip.
Page 12