Instructions

tams elektronik
English LC-Modules Next Generation
Checking the contents of the package
After unpacking, check the contents of the package:
 a kit consisting of all the components listed in the parts list (page 17)
and a circuit board or
 a ready-made module or
 a ready-made module with housing;
 additionally for modules LC-NG-01 and LC-NG-02 (from software
version 06/2021): a diode 1N400x, x = 2...7.
Lights, LEDs, servos and loudspeakers that can be connected to the
outputs of the LC-NG modules as well as any additional components
that may be required are not included in the scope of delivery.
To assemble the kit you will need
 a soldering iron with temperature control and a thin tip and a deposit
stand or a controlled soldering station
 a scraper, rag or sponge
 a heat-resistant pad
 a small pair of side cutters and wire strippers
 tweezers and flat-nose pliers if necessary
 electronic solder (preferably 0.5 to 0.8 mm diameter)
For the power supply you need
 an AC transformer with 10 to 18 volts nominal voltage or
 a DC power supply unit with 10 to 22 volts nominal voltage
You can connect several LC-NG modules or other consumers/circuits to
one transformer or one power supply unit. To improve clarity, the use
of a distribution board is recommended (e.g. Power-Block item no. 72-
00315 or 72-00316).
Page 6