Instructions

tams elektronik
LC-Modules Next Generation English
7.9. Configuration
For some modules, you can set one of two or more variants after
switching to programming mode.
LC-NG-02, LC-NG-04, LC-NG-06 and LC-NG-08:
Setting a programme variant
To switch to programming mode, proceed as follows:
 Switch off the power supply and set the trim potentiometer to the
right stop.
 Connect the switching input to ground by pressing the switch,
holding the push-button or connecting the terminals "IN" and " -/ ".
 Switch the power supply on again.
 After switching on the power, disconnect the switching input from
earth by pressing the switch, releasing the button or disconnecting
the connection between the terminals "IN" and " -/ ".
 The module is now in programming mode.
 To switch between the two variants, briefly connect the switching
input "IN" to earth.
Display of the set variant for LC-NG-02 and LC-NG-04:
The respective set variant is displayed on the connected LEDs or lamps.
LC-NG-02 LC-NG-04
Outputs 1-7 on House 1 & 2 modern street lamps
Outputs 8-14 on House 3 & 4 gas lanterns
Display of the set variant for LC-NG-06 and LC-NG-08:
The set variant is immediately displayed on the connected LEDs or
lamps.
Page 35