Instructions
Table Of Contents
- Part A: General information
- Part B: LC-NG versions
- 1. LC-NG-01 "City Lighting"
- 2. LC-NG-02 "Residential buildings"
- 3. LC-NG-03 "Office and commercial buildings"
- 4. LC-NG-04 "Street lamps"
- 5. LC-NG-05 "Road traffic"
- 6. LC-NG-06 "Emergency vehicles"
- 7. LC-NG-07 "(Road) construction site"
- 8. LC-NG-08 "Fire station"
- 9. LC-NG-09 "Railway station"
- 10. LC-NG-10 "Workshop"
- 11. LC-NG-11 "Flickering flames & candle lights"
- 12. LC-NG-12 "Event"
- 13. LC-NG-13 "Chaser lights"
- 14. LC-NG-14 "Funfair lighting"
tams elektronik
English LC-Modules Next Generation
7.1. Connection to the power supply
Use the following as power supply
an AC transformer with 10 to 18 volts nominal voltage or
a DC power supply unit with a nominal voltage of 10 to 22 volts.
When connecting to DC voltage, you must always observe the polarity.
When connecting to an AC transformer, the polarity is not important at
first. If you connect several LC-NG modules to a transformer, you must
always assign the connections of the modules to the transformer
connections in the same way.
To keep track when connecting several LC-NG modules to a common
power supply, the use of a distribution board is recommended.
Example: Connecting 13 LC-NG modules to one distribution board Power-Block
(item no. 72-00315 or 72-00316)
Up to 13 circuits (or other loads) can be connected to one power block. If further circuits or
consumers are to be connected to a common voltage source, further Power-Blocks can be
cascaded.
Note on the illustration: The power distribution board is shown enlarged 4 times in relation to
the LC-NG modules.
Page 20