Instructions

tams elektronik
LC-Modules Next Generation English
Using the switching input (version before 06/2021)
Until June 2021, the LC-NG-02 modules were delivered with a software
variant in which the switching input is used to switch between the two
programme variants. Synchronisation with other LC-NG-02 modules is
not possible with this variant. You can recognise this version by the
information on the packaging and by the fact that no diode is included
in the delivery.
Switching input Effect
Please note that this
table only applies to
the software version
that was not supplied
with a diode!
open "House 1 & 2"
programme
closed (switched to earth) "House 3 & 4"
programme
Tip: If you install a switch in the supply line to the switching input, you can switch between the two
programme versions as desired.
Settings on the trim potentiometer
At the trim potentiometer you set the time factor, i.e. how many
milliseconds in the programme sequence correspond to one minute in
real life. The time factor decreases in the left-hand direction of rotation
and increases in the right-hand direction of rotation.
Time factor Setting 1 Minute ≙ Total duration of the sequence
4 * left* 40 ms 57.600 ms (approx. 60 sec.)
44 right 480 ms 691.200 ms (approx. 12 min.)
*Note: If the trim potentiometer is set to the left stop, the module goes into test mode when it
is switched on. You must therefore turn the potentiometer a little to the right to set the lowest
time factor after you have set it to the left stop.
Configuration
To switch between the programme versions "House 1 & 2" and "House
3 & 4", proceed as described on page 36.
Page 51