Instructions

tams elektronik
LC-Modules Next Generation English
To switch to programming mode, proceed as follows:
 Switch off the power supply and set the trim potentiometer to the
right stop.
 Connect the switching input to earth, by pressing the switch, holding
the push-button or connecting the terminals "IN" and " -/ ".
 Switch the power supply on again.
 After switching on the power, disconnect the switching input from
earth by pressing the switch, releasing the button or disconnecting
the connection between the terminals "IN" and " -/ ".
 The module is now in programming mode.
To activate or deactivate a variant, first select the variant by turning the
trimmer potentiometer:
 Left stop: Variant 1
 Right stop: Variant 8
The set variant is indicated by switching on or off the light or LED at
the assigned output. Note that for the currently selected variant, the
state that the variant has after confirming the setting is displayed:
 LED/light off: Variant is active, becomes inactive after confirmation.
 LED/light on: Variant is inactive, becomes active after confirmation.
To (de)activate the set variant, briefly connect the switching input to
earth, by switching the switch on and off, pressing the push-button or
briefly connecting the connections "IN" and " -/ ". The setting is saved.
You can activate or deactivate further variants afterwards. Switch off
the power supply. The next time the module is switched on, the active
programme variants run one after the other.
Page 39