Instructions
Table Of Contents
- Part A: General information
- Part B: LC-NG versions
- 1. LC-NG-01 "City Lighting"
- 2. LC-NG-02 "Residential buildings"
- 3. LC-NG-03 "Office and commercial buildings"
- 4. LC-NG-04 "Street lamps"
- 5. LC-NG-05 "Road traffic"
- 6. LC-NG-06 "Emergency vehicles"
- 7. LC-NG-07 "(Road) construction site"
- 8. LC-NG-08 "Fire station"
- 9. LC-NG-09 "Railway station"
- 10. LC-NG-10 "Workshop"
- 11. LC-NG-11 "Flickering flames & candle lights"
- 12. LC-NG-12 "Event"
- 13. LC-NG-13 "Chaser lights"
- 14. LC-NG-14 "Funfair lighting"
tams elektronik
LC-Modules Next Generation English
To switch to programming mode, proceed as follows:
Switch off the power supply and set the trim potentiometer to the
right stop.
Connect the switching input to earth by pressing the switch, holding
the push-button or connecting the terminals "IN" and " -/ ".
Switch the power supply on again.
After switching on the power, disconnect the switching input from
earth by pressing the switch, releasing the button or disconnecting
the connection between the terminals "IN" and " -/ ".
The module is now in programming mode.
Then set one of the programme variants by turning the trim
potentiometer:
Left stop: Variant 1
Right stop: Variant 8. Note: Eight variants are technically possible,
but may not be available for the LC-NG version you are currently
configuring.
The set variant is indicated by the light or LED at the assigned
output lighting up.
As soon as the desired variant is set, briefly connect the switching input
to earth by switching the switch on and off, pressing the push-button or
briefly connecting the terminals "IN" and " -/ ". The selected variant is
saved.
Switch off the power supply. The next time the module is switched on,
the set variant is active.
Page 37