Instructions
Table Of Contents
- Part A: General information
- Part B: LC-NG versions
- 1. LC-NG-01 "City Lighting"
- 2. LC-NG-02 "Residential buildings"
- 3. LC-NG-03 "Office and commercial buildings"
- 4. LC-NG-04 "Street lamps"
- 5. LC-NG-05 "Road traffic"
- 6. LC-NG-06 "Emergency vehicles"
- 7. LC-NG-07 "(Road) construction site"
- 8. LC-NG-08 "Fire station"
- 9. LC-NG-09 "Railway station"
- 10. LC-NG-10 "Workshop"
- 11. LC-NG-11 "Flickering flames & candle lights"
- 12. LC-NG-12 "Event"
- 13. LC-NG-13 "Chaser lights"
- 14. LC-NG-14 "Funfair lighting"
tams elektronik
!
English LC-Modules Next Generation
7.6. Connecting a servo (LC-NG-07,-08,-10)
Connecting a servo is only possible with LC-NG modules that have a
corresponding output. The servo signal of the LC-NG modules is a 50
Hz signal (20 ms period length), which slowly changes between 1
millisecond (left stop = 0 degrees) and 2 milliseconds (right stop, 90
degrees).
You need a servo set (item no. 53-04321-01) or a servo and also
as current and voltage supply for the servo: a servo board (item no.
70-05900)
a 470 Ω resistor
Please n
ote:
The connection shown differs from the standard
connection of the servo board according to the instructions. In combination
with the LC-NG module, the connection must be made in accordance with
this illustration, otherwise errors will occur during servo control.
Page 32