User manual

tams elektronik
English WBA-1 | WBA-2 | WBA-3
Required materials
For assembling the kit you need:
 an electronic soldering iron (max. 30 Watt) or a regulated soldering
iron with a fine tip and a soldering iron stand,
 a tip-cleaning sponge,
 a heat-resistant mat,
 a small side cutter and wire stripper,
 as necessary a pair of tweezers and long nose pliers,
 electronic tin solder (0,5 mm. Diameter),
 thin connecting wire.
2. Safety instructions
Mechanical hazards
Cut wires can have sharp ends and can cause serious injuries. Watch
out for sharp edges when you pick up the PCB.
Visibly damaged parts can cause unpredictable danger. Do not use
damaged parts: recycle and replace them with new ones.
Electrical hazards
 Touching powered, live components,
 touching conducting components which are live due to malfunction,
 short circuits and connecting the circuit to another voltage than
specified,
 impermissibly high humidity and condensation build up
can cause serious injury due to electrical shock. Take the following
precautions to prevent this danger:
 Never perform wiring on a powered module.
 Assembling and mounting the kit should only be done in closed,
clean, dry rooms. Beware of humidity.
Page 4