User manual

tams elektronik
English LC modules
LC-16 "Dim switch for street lamps": The input JP2 is switched on
and off automatically via a light sensitive switch. The sensitivity of the
switch is set via a trimpot.
Four outputs are designed for the connection of street lamps. The street
lamps are getting brighter gradually after being switched on and obtain
their maximum brightness after about one minute. Additional accessories
(e.g. house lightings) which are intended to be switched depending on
the ambient lighting can be connected to output 1 via a relay.
The circuit responds to changes of the ambient lighting with a delay of
some seconds. While the street lamps are getting brighter after being
switched on and some seconds after being switched off, the circuit does
not respond to changes of the ambient lighting.
LC-17 "Speed trap": The output 1 controls the speed trap, which
flashes at irregular intervals (from approx. 3 to 25 seconds). The outputs
2 to 5 are assigned for connecting the flash lights of police cars. The
outputs 2 and 3 produce an asynchronous double flashing light (for
modern police cars), the outputs 4 and 5 an asynchronous flashing light
(for older police cars). The input JP2 has no function in this version.
Tip: The effect of the light patterns is most realistic when a white LED with
high luminosity is connected to the output 5, blue LEDs are connected to
the outputs 2 and 3 and small blue bulbs to the outputs 4 and 5.
LC-18 "Vehicle lighting": Via the switching input JP2 you can set
the following programs: "moving vehicle" (with the input open) or
"standing vehicle" (with the input switched to earth).
Assignment of the outputs:
1: Flashing lights on the left
2: Flashing lights on the right
3: Interior light (standing vehicle) or horn (moving vehicle)
4: Front lights
5: Back lights / brake lights
Page 14