User manual

tams elektronik
English LC modules
LC-8 "Advertising light 4": Fusion of the advertising lights 1 to 3,
coming on one after the other. If the input JP2 is switched to earth, the
light sequence switches off after the completion of the active part of
the program. If the input JP2 is switched to earth, the light sequence is
interrupted. If the input remains opens, the program is repeated
constantly.
LC-9 "Ignition module for gas lamps": If the input JP2 is given a
short electric pulse (earth), the gas lamps start to flicker and grow
brighter gradually. Every ignition process is slightly different. After
approx. 5 seconds the gas lamps reach their maximum brightness.
During operation, the lamps flicker now and then at different times
(variations of gas pressure). After the switch-off impulse, (when the
input JP2 is given a short electric pulse) all lamps shine on with
moderate brightness and go off completely in approx. 1.5 seconds.
LC-10 "Fluorescent tube simulator: If the input JP2 is given a short
electric pulse (earth), the different fluorescent tubes flicker for a moment
before all of them light one after the other - just like the real thing. The
turning on pattern is a little different for each. If the input JP2 is switched
to earth shortly, the light switches off. When the input is switched to
earth permanently, a defective tube is simulated on output 1. This tube
flickers at irregular intervals, at times brightening quickly, at times slowly.
LC-11 "Occupied house": Two different programs are available.
Program 1, "Home", starts if the input JP2 is switched to earth,
Program 2, "Office", if the input remains opens. The programs take
approximately 15 minutes and are repeated after a short pause.
Program 1: First the light in the kitchen (output 1) goes on for a while,
followed a bit later by the living room (output 2). Output 3 is assigned for
connecting a blue light bulb (the TV set), which flickers like a television
picture. Some time later the light in the kitchen switches off, and goes on
again once during the program flow. The light in the bathroom (output 4)
Page 12