User manual

tams elektronik
!
LC modules English
Parallel connection of LEDs
With a parallel connection each LED has to be connected via it´s own
series resistor to the output. The total current at the output results
from summing up the current of each single LED.
The current consumption of one LED depends on the value of the series
resistor. The higher the value, the lower is the current and the more
LEDs can be connected to one output. But, the LEDs light the darker,
the higher you choose the series resistor´s value.
Caution: The maximum current of 100 mA per output should not
be exceeded. In this case the output would be damaged.
Page 25